This is a library of perfboard and single-sided PCB effect layouts for guitar and bass. I'm not an electrical engineer by any stretch of the imagination, just a DIY'er who likes drawing layouts. It is meant for the hobbyist (so commercial use of any of these layout is not allowed without permission) and as a way to give back to the online DIY community.

Friday, May 3, 2019

Royal Albert Hall Bender

Happy Fuzz Friday everyone! Got a request for this one put forth on FSB. It's based on the ThroBak sTone Bender, which itself is just a straight clone of the Tone Bender Mk II Professional. The layout is setup for positive ground and PNP transistors. You can use a voltage inverter daughter board or flip any polarized components and use NPN transistors if you want to daisy chain this with other effects. Also, I added a 1k limiting resistor of the bias pot (far upper right side of the board) that may need to be adjusted to taste. Easy fit in a 1590B.

13 comments:

  1. How to contact you personally? I got few general question but i don't want to spam irrelevant topic on your page. Thanks.

    ReplyDelete
    Replies
    1. Email address is in comments in the General Layout Notes page, or message me on Facebook.

      Delete
    2. i sent message on facebook but no luck. i guess email is fine.

      Delete
  2. will try today, thanks, David!

    ReplyDelete
  3. Verified. NpN version with MP35 Russian Germanium transistors and 390 Ohm resistor instead 1K (but i try other value later). Thank you again.

    ReplyDelete
  4. first cascade made darlington like animato: npn+pnp mp38a + mp 42b, bias resistor should change.very cool sustain.

    ReplyDelete
  5. Anyone got problems with low output volume. How can you increase it?

    ReplyDelete
  6. Built it with Q1,Q2,Q3 mp38a, any troubles with output volume!Super bender, i like it!

    ReplyDelete