This is a library of perfboard and single-sided PCB effect layouts for guitar and bass. I'm not an electrical engineer by any stretch of the imagination, just a DIY'er who likes drawing layouts. It is meant for the hobbyist (so commercial use of any of these layout is not allowed without permission) and as a way to give back to the online DIY community.

Wednesday, June 29, 2016

Lovepedal Delux 60 Mosfet Boost

Hadn't done a boost pedal in a while and hadn't done a Lovepedal pedal in a while either, so I'm killing 2 birds with one stone. The Delux 60 uses a Mosfet gain stage set to give clean boost or to push a tube amp into break up. It's simple but effective. This'll fit into a 1590a pretty easily too.

12 comments:

  1. Holaa... Aca puedo invertir el 2N7000???

    ReplyDelete
    Replies
    1. You can, though it might not be as loud as a BS170.

      Delete
  2. Just soldered it - works like a charm! Please tag it as verified.

    ReplyDelete
  3. I don't have at home any 3K3 resistors. If I build it with 3K the result will be a slightly less loud booster? Or significantly less loud? I have 3K or 3K9 nothing in between.

    ReplyDelete
    Replies
    1. 3k should be fine and shouldn't sound all that different.

      Delete
    2. In the end I put there a 3K and a 300 Ohm resistor in a shrink tube. But it is too late to try it now...

      Delete
  4. It works, the drawing is good. I built a few pedals from the drawings here. Thanks for them.

    ReplyDelete
  5. Any hint on how to add gain pot? Thanks a bunch.been this site's fan since three four years ago and jad built several pedals from several posts in here.thank for your work storyboardist 😘😊

    ReplyDelete
    Replies
    1. Put like a C5k pot in place of the 330Ω resistor on the left side.

      Delete
  6. Hi! Im new at diy's world. Can you show me how to wire this pcb to the input, output and 9v jacks?

    ReplyDelete