This is a library of perfboard and single-sided PCB effect layouts for guitar and bass. I'm not an electrical engineer by any stretch of the imagination, just a DIY'er who likes drawing layouts. It is meant for the hobbyist (so commercial use of any of these layout is not allowed without permission) and as a way to give back to the online DIY community.

Wednesday, June 29, 2016

Lovepedal Delux 60 Mosfet Boost

Hadn't done a boost pedal in a while and hadn't done a Lovepedal pedal in a while either, so I'm killing 2 birds with one stone. The Delux 60 uses a Mosfet gain stage set to give clean boost or to push a tube amp into break up. It's simple but effective. This'll fit into a 1590a pretty easily too.

at
Labels: , , ,

12 comments:

  1. FacundoMarch 16, 2017 at 11:47 AM

    Holaa... Aca puedo invertir el 2N7000???

    ReplyDelete
    Replies
    1. Effects LayoutsMarch 16, 2017 at 11:49 AM

      You can, though it might not be as loud as a BS170.

      Delete
  2. sbMay 1, 2017 at 10:34 AM

    Just soldered it - works like a charm! Please tag it as verified.

    ReplyDelete
  3. UnknownMarch 24, 2018 at 7:34 PM

    I don't have at home any 3K3 resistors. If I build it with 3K the result will be a slightly less loud booster? Or significantly less loud? I have 3K or 3K9 nothing in between.

    ReplyDelete
    Replies
    1. Effects LayoutsMarch 24, 2018 at 9:04 PM

      3k should be fine and shouldn't sound all that different.

      Delete
    2. UnknownMarch 24, 2018 at 10:02 PM

      In the end I put there a 3K and a 300 Ohm resistor in a shrink tube. But it is too late to try it now...

      Delete
    3. UnknownMay 29, 2018 at 2:11 PM

      Working?

      Delete
  4. MishaOctober 30, 2019 at 5:04 PM

    It works, the drawing is good. I built a few pedals from the drawings here. Thanks for them.

    ReplyDelete
  5. JunmarFusilleroDecember 9, 2019 at 9:26 AM

    Any hint on how to add gain pot? Thanks a bunch.been this site's fan since three four years ago and jad built several pedals from several posts in here.thank for your work storyboardist 😘😊

    ReplyDelete
    Replies
    1. Effects LayoutsDecember 9, 2019 at 1:15 PM

      Put like a C5k pot in place of the 330Ω resistor on the left side.

      Delete
  6. AlexisDecember 14, 2019 at 9:43 AM

    Hi! Im new at diy's world. Can you show me how to wire this pcb to the input, output and 9v jacks?

    ReplyDelete

Subscribe to: Post Comments (Atom)