This is a library of perfboard and single-sided PCB effect layouts for guitar and bass. I'm not an electrical engineer by any stretch of the imagination, just a DIY'er who likes drawing layouts. It is meant for the hobbyist (so commercial use of any of these layout is not allowed without permission) and as a way to give back to the online DIY community.
Always need more bass effects, right? This was one of the first bass ODs to have a clean blend. Should be an easy fit in a 1590B. Here's the schematic for reference.
So! Catching fleas :) According to the scheme: 220nF need to ground. 47nF (near BLEND (2)) should be 470p. All pass-through 10uF - polarity should be in the opposite direction.
Right you are! Never seen a decimal used with nF values like that. Fixed all but the blend lugs as I believe that's how it was on the originals—dry signal counter clockwise, effected signal clockwise.
What would it be - dry signal counter clockwise, effected signal clockwise - need to swap 1 and 3 BLEND. I know what I'm talking about - in front of me is a working layout ;)
Made it. Nice sound. Altough I'm not sure the blend is working as it should. When set to dry It still sounds distorted, but with less volume. Never get a dry sound if Drive is set past mid.
Can I replace 4560D to 4558D or 4580D?
ReplyDeleteYeah. Any dual opamp should work
DeleteI have done it. Layout works.
ReplyDeleteBLEND - need to swap 1 and 3.
So! Catching fleas :) According to the scheme:
Delete220nF need to ground.
47nF (near BLEND (2)) should be 470p.
All pass-through 10uF - polarity should be in the opposite direction.
Right you are! Never seen a decimal used with nF values like that. Fixed all but the blend lugs as I believe that's how it was on the originals—dry signal counter clockwise, effected signal clockwise.
DeleteWhat would it be - dry signal counter clockwise, effected signal clockwise - need to swap 1 and 3 BLEND.
ReplyDeleteI know what I'm talking about - in front of me is a working layout ;)
Thanks for your work!
Okay so what would happen if i replaced the 100ks with 250k pots?
ReplyDeleteSound test my version DIY DOD FX91 Bass Overdrive:
ReplyDeletehttps://youtu.be/hyQs4XS_niY
\m/ \m/
ReplyDelete我用500p替代了470p，用100p替代了120p，用4558替代了4560，我得到的增益很小，我应该改正吗？
ReplyDeletei made it, works ok, very low gain, so much pop, anyone had a suggestion to stop this pop? I ever had 1m do infx to gnd. Thanks
ReplyDeleteFlip the 10uf input cap.
DeleteThannnks
DeleteThe 10uf input cap needs to be flipped. Currently the negative side is going to the transistor.
ReplyDeleteMade it. Nice sound. Altough I'm not sure the blend is working as it should. When set to dry It still sounds distorted, but with less volume. Never get a dry sound if Drive is set past mid.
ReplyDelete