This is a library of perfboard and single-sided PCB effect layouts for guitar and bass. I'm not an electrical engineer by any stretch of the imagination, just a DIY'er who likes drawing layouts. It is meant for the hobbyist (so commercial use of any of these layout is not allowed without permission) and as a way to give back to the online DIY community.

Friday, April 3, 2015

Lovepedal Amp Eleven

The overdrive section of the Amp Eleven as many of you might know, is pretty much a direct copy of Paul Cochrane's Timmy. The only difference (aside from a few value changes) is the Amp Eleven doesn't have the switch that adds another clipping section that's in the Timmy.


6 comments:

  1. Verified!! Fantastic pedal, too much versatile, can get a classic fender tone and in higher drive configurations a very cool fuzz.I made It together with the cot50, thats a killer conbination. Just found a little inssue: pin 1 and 3 on drive pot are inverted ;).
    Thanks you for this amazing pedal!!

    ReplyDelete
    Replies
    1. Thanks for the verify! Updated the layout to reflect the correct wiring of the drive pot.

      Delete
  2. Verified! Great pedal, sounds awesome. I have just a little hiss on high gain settings, but i guess its my connections.

    ReplyDelete
  3. Can I use 1uF polarized electrolitic caps instead non polarized?, I`ve build a TS808 with them oriented negative to ground with no problems.

    ReplyDelete
  4. I Buit the pedal using the PCB , but It have no gain, only clean signal, and when I turn the gain to max, whe pedal sound much treble

    ReplyDelete
  5. How do you connect the 3pdt and the potentiometer both of the Booster stage as it appears in the videos?

    ReplyDelete