This is a library of perfboard and single-sided PCB effect layouts for guitar and bass. I'm not an electrical engineer by any stretch of the imagination, just a DIY'er who likes drawing layouts. It is meant for the hobbyist (so commercial use of any of these layout is not allowed without permission) and as a way to give back to the online DIY community.

Thursday, October 1, 2020

Grind Customs FX Tenebrion

 The Tenebrion was designed by CultureJam and is the further development of the Box of Hall reverb. It uses the Belton BTDR-2 reverb brick, which I've designed to fit on the solder-side of the circuit board. You should be able to squeeze it into a 1590B.







at
Labels: , , ,

9 comments:

  1. theeggmanOctober 2, 2020 at 5:12 AM

    Nice build !!

    Do you have a link for the schematic ?

    ReplyDelete
  2. Arnold DikstaalOctober 3, 2020 at 2:34 PM

    Which BTDR-2 is used? Long/medium/short?
    Could you upload a bigger picture? When I click on it it seems even smaller :)

    ReplyDelete
    Replies
    1. Effects LayoutsOctober 3, 2020 at 3:27 PM

      Which ever length you prefer. Sorry about the image. Google has changed the backend of blogger and I'm not used to it yet.

      Delete
  3. naivecyMarch 31, 2021 at 1:59 AM

    can i modify power filter section just like the other circuits with 1n4001(going between +9v and gnd)?
    i don’t have any 1n5817s ;)

    ReplyDelete
    Replies
    1. Effects LayoutsMarch 31, 2021 at 9:43 PM

      You can or you can use the 4001 as a sub for the 5817. You'll just have little bit more voltage drop that you would with the 5817, but it will still work fine.

      Delete
  4. dsfAugust 30, 2021 at 8:04 PM

    Verified, but the tone is subtle. any sugestion for more range?

    ReplyDelete
  5. dsfJune 28, 2023 at 8:49 AM

    Is just upper the 47n cap, 100n or 150n is ok. the tone cut more treble.

    ReplyDelete

Subscribe to: Post Comments (Atom)