This is a library of perfboard and single-sided PCB effect layouts for guitar and bass. I'm not an electrical engineer by any stretch of the imagination, just a DIY'er who likes drawing layouts. It is meant for the hobbyist (so commercial use of any of these layout is not allowed without permission) and as a way to give back to the online DIY community.

Thursday, July 18, 2019

Fulltone OCD V2

The latest iteration of the OCD has quite a few differences from the earlier models. There's an added transistor stage at the output after the volume control, and a JFET buffer that can be toggled for buffered or true bypass. I've laid it out so it will still fit in a 1590B with board mounted pots.






The off-board wiring's not the most intuitive, so here's a diagram for wiring up the buffer switch and 3PDT bypass footswitch.

at
Labels: , ,

15 comments:

  1. plushJuly 19, 2019 at 4:04 AM

    https://www.youtube.com/watch?v=h3uBr0CCm58

    ReplyDelete
  2. Arnold DikstaalJuly 19, 2019 at 6:06 AM

    Schematic?

    ReplyDelete
  3. Arnold DikstaalJuly 19, 2019 at 6:29 AM

    When looking at the On Semiconductor datasheet I think you need to rotate the 2N5457 180 degrees. So always check your transistor pinout before soldering :)

    ReplyDelete
  4. ZZOYDJuly 20, 2019 at 11:49 AM

    Thank you great, David!

    ReplyDelete
  5. MonjeJuly 26, 2019 at 1:24 PM

    Checked! Sounds beautifully, it took a little work to finish, many wires to solder, I made a small change to be able to switch between clipping the 2n7000 and some red LEDs, there is a small change in the sound but I still don't know if it's worth it. Thanks for more this great layout!

    ReplyDelete
  6. ZZOYDSeptember 2, 2019 at 12:45 PM

    I have slight overdrive, when i use buffer. Without (direct) buffer - clear signal. Is anybody have same problem? Used 2n5457 transistors.

    ReplyDelete
    Replies
    1. UnknownDecember 2, 2019 at 8:25 AM

      Yes, same problem here. I tried some 2n5458, and J201 it is working little bit better (louder). On true bypass there is no problem. Will try some SMD versions of 2n5457... think, i might have some "fake" out of specs 2n5457...

      Delete
    2. UnknownDecember 2, 2019 at 11:05 AM

      I just try mmbf5457 on adapter, works perfect with them... no volume loss at all on buffered mod... just pickup up some good 2n5457 or SMD version... ;-)

      Delete
  7. Nicolini de SemolaApril 26, 2021 at 9:31 AM

    hi everyone, i did this great pedal and it works well but I feel it needs a little more definition in the high end, sharpen the sound a little bit. Do you think this could be due to bad 2N5457 ICs ? thanks.

    ReplyDelete
    Replies
    1. Effects LayoutsApril 27, 2021 at 4:30 PM

      Not likely to be semiconductors. You may just need to adjust some cap values to taste.

      Delete
  8. ClassicFuzzSeptember 16, 2022 at 2:21 PM

    Verified, and built it with a switch to switch between V2 and the Custom GE Version. Is it correct that unity is somewhere between 12 and 1?

    ReplyDelete

Subscribe to: Post Comments (Atom)