This is a library of perfboard and single-sided PCB effect layouts for guitar and bass. I'm not an electrical engineer by any stretch of the imagination, just a DIY'er who likes drawing layouts. It is meant for the hobbyist (so commercial use of any of these layout is not allowed without permission) and as a way to give back to the online DIY community.

Tuesday, January 22, 2019

Way Huge Tone Leper

This is a rare one from the early 90s from Way Huge and is based on the Craig Anderton Frequency Booster. Stock it gives a mid range boost (800Hz), but that frequency can be altered by swapping the 2, 22nF caps:

220nF - 90Hz (lows)
100nF - 200Hz (low mids)
10nF - 2kHz (mids)
4.7nF - 4kHz (upper mids)


at
Labels: , ,

7 comments:

  1. H.A.January 22, 2019 at 11:35 AM

    Add a clean blend and you have a basic audio freq peak. ;-)

    ReplyDelete
  2. PeteJanuary 22, 2019 at 11:58 AM

    Verified. You may want to indicate the +9vdc location on the drawings and/or remove the extra ground solder lug at the 100uf negative pole location, just to avoid confusion for some of the new folks.

    ReplyDelete
    Replies
    1. Effects LayoutsJanuary 22, 2019 at 5:07 PM

      Just forgot to add the label. Updated now. Thanks for verifying, Peter!

      Delete
  3. blakolJanuary 23, 2019 at 8:38 AM

    Is it not a LF353 instead the LM353?

    ReplyDelete
  4. shimanekoJanuary 26, 2019 at 6:04 AM

    I built it with a 2pole-6position rotary and a daughter board of caps as shown here:
    http://tagboardeffects.blogspot.com/2017/04/way-huge-tone-leper.html#comment-form.
    IMHO, 5.6k resistor should be connected to lug1&2 and lug3 to opamp's Pin7 to make gain-up/turn-clockwise combination, though it is a matter of taste.
    Thanks for an awesome layout as usual.

    ReplyDelete
  5. UnknownJune 11, 2021 at 9:31 AM

    Is it true by pass already?

    ReplyDelete

Subscribe to: Post Comments (Atom)