This is a library of perfboard and single-sided PCB effect layouts for guitar and bass. I'm not an electrical engineer by any stretch of the imagination, just a DIY'er who likes drawing layouts. It is meant for the hobbyist (so commercial use of any of these layout is not allowed without permission) and as a way to give back to the online DIY community.

Monday, February 13, 2017

Electro Harmonix Soul Preacher

There have been a few different iterations of the Soul Preacher. This one follows the version that isn't based around an OTA chip (much like a DynaComp), but is rather much closer to an Orange Squeezer. The original used a buffered bypass, and I've included an extra pad for the buffer out if you want to build it that way. Here's the schematic for reference.

19 comments:

  1. what would i need to change to make it work ok with bass guitar?

    ReplyDelete
    Replies
    1. It may work fine as is. But if not, probably some capacitor values. You'd have to experiment.

      Delete
  2. would i need to jumper the pads for buffer if i elect not to use a buffer?

    ReplyDelete
  3. I bet that germanium can't be replaced, am I right?

    ReplyDelete
  4. My build has too much clipping, what could it be?

    ReplyDelete
  5. esta es la replica del soul food ? necesito ese eecto .sonaria genial.

    ReplyDelete
    Replies

    1. No, the Soul Food is a Klon copy. This is a compressor

      Delete
  6. I'm confused about the out and buffered out how do you use these two together?

    ReplyDelete
    Replies
    1. To use the buffered out you'd use a DPDT footswitch. Wire the In pad to the input jack, the Out pad to lug 1 of the footswitch, lug 2 to the output jack, and lug 3 to the Buffered Out pad. Then use the other side of the footswitch for LED on/off indication. The input buffer of the circuit will always be in the signal path, with the compressor portion bypassed by the footswitch.

      Delete
  7. Verified!!! I did the pcb version and it works well, it looks very good with ne5532. thanks, your work with the layouts is amazing !!!

    ReplyDelete
  8. Ready to build this one this week!

    ReplyDelete
  9. has anyone tried with 4148 instead of 1n34a?

    ReplyDelete
  10. There is a lot of clipping. Does anyone has that problem?

    ReplyDelete