This is a library of perfboard and single-sided PCB effect layouts for guitar and bass. I'm not an electrical engineer by any stretch of the imagination, just a DIY'er who likes drawing layouts. It is meant for the hobbyist (so commercial use of any of these layout is not allowed without permission) and as a way to give back to the online DIY community.

Monday, April 25, 2016

Cornish SS-2

With the G-2 fresh in our minds, I thought I'd draw up the SS-2 as well. This is set up for a 125B like the G-2 due to the footswitch board. The circuit itself is like an MXR Distortion + with a tone control and a gain recovery stage. Originals utilize 2, LM741 chips, but I've drawn it up for a LM1458 (which is a dual version of the 741) to make things a little easier and save space.



21 comments:

  1. this 1N5401 diode can be replaced by 1N4002 ? tanks

    ReplyDelete
  2. I am really excited about this layout. I have a question regarding the layout above. Which is correct on the layout above for the 4.7N and 10N? Do they go up and down or side to side because the 2 diagrams are different. do they both go to drive 2? I really appreciate your help.

    ReplyDelete
    Replies
    1. The PCB version is different because I'm not tied to 0.1" spacing like I am with perf. The connections made are the same though. If you're building on perf follow the left layout. If you're etching a PCB follow the right.

      Delete
  3. I finished creating this pedal. I built the buffer and connected them together just like the original. I like the 1458 instead of 2 LM741's. I am still boxing this but it sounds great. Thank you for your awesome Layout.

    ReplyDelete
  4. I finally finished this build with the buffer. It really sounds amazing. I decided to put it in true by pass rather than wire it inline like the original. The buffer is there if you hit the switch which keeps the tone correct. Here is a link to my build.

    https://4.bp.blogspot.com/-kQls8oMG6Yk/VzCO7OxctqI/AAAAAAAAAcQ/T8IDBlXjF58nDSycoK1UBv89cr8j2n8qQCLcB/s1600/cornishss2.png

    ReplyDelete
    Replies
    1. Here is a link to how the original is wired if anyone is interested.

      http://tagboardeffects.blogspot.com/2014/04/cornish-g2.html

      Delete
    2. Thank you so much for your complement. I really love this site. I etched the G2 and double buffer as well. Can't wait to build them. I have built both with Vero but it will be cool with PCB. Thank you again for your hard work.

      Delete
    3. Hi Dennis, can you tell me how to wiring this pedal with 3pdt?

      Delete
  5. Thanks for the layout!! I can't wait to try it!

    ReplyDelete
  6. Sorry, I'm making a bit of a mess with this post....
    I built SS2 but I have a little problem: when I turn drive pot it has effect only at the end of its turn. Please can anyone help me? Thanks

    ReplyDelete
    Replies
    1. Make sure the pot is good and that you're using the right value. You can also try using a 100k pot instead of 50k.

      Delete
    2. Thanks for your answer....
      I solve the problem and i hope it is a suggestion for anyone: i replaced linear B50k pot with a reverse C50k and now all works perfectly. Great stomp!

      Delete
  7. It works, the drawing is good. I built a few pedals from the drawings here. Thanks for them.

    ReplyDelete
  8. I replaced the drive pot with a c50k too and now it works great!!!
    thanks for the layout!!!

    ReplyDelete