This is a library of perfboard and single-sided PCB effect layouts for guitar and bass. I'm not an electrical engineer by any stretch of the imagination, just a DIY'er who likes drawing layouts. It is meant for the hobbyist (so commercial use of any of these layout is not allowed without permission) and as a way to give back to the online DIY community.

Friday, February 13, 2015

Marshall Blues Breaker Mk.I

The Blues Breaker was designed to emulate the vintage 2x12 Marshall combo, and was introduced by Marshall in 1991. Great at pushing a clean amp into breakup and sounds great with single coils. There has since been a Bluesbreaker II, which many claim to be inferior to the original. This layout is for the original model with onboard pots and will fit in a 1590B.




Note that the PCB layout is half a row (0.05 in/1.27mm) taller than the perf layout.

20 comments:

  1. Hi, This layout is verified: https://scontent-dfw1-1.xx.fbcdn.net/hphotos-xpt1/v/t34.0-12/11297761_809615919128433_1138598537_n.jpg?oh=6ffa7d5d622a7f2ec3f6b4904ff4465b&oe=557E962D

    ReplyDelete
  2. https://www.youtube.com/watch?v=RQBoJDKmm6U

    ReplyDelete
  3. Why dont you publish the schematics as well ?
    Elico
    therightinfo@gmail.com

    ReplyDelete
    Replies
    1. If I don't draw the schematic myself I don't post it. Often times I'll link to it, especially if it's from a source with extra information on the circuit like RunOffGroove.com or a FSB/DIYSB thread. Typically though, the schematics are easily found online. A little Google searching never hurt anyone. ;)

      Delete

  4. Good I see some values ​​of condendadores like in the input among others of 100nf but it reviews other schemes and uses 10nf had my doubts on those values, and is the project verified?

    ReplyDelete
  5. Hi Thank You for your amazing work! I have a question: what if I use a 50K Pot intead of the 25?
    Thank You

    ReplyDelete
    Replies
    1. It would work, tho the range would probably be a little weird. I'd throw a 47k resistor from lug 1 to lug 3 of your 50k pot. That'll reduce the pots value down to about 25k.

      Delete
    2. Thank You, sure I will try!!

      Delete
  6. Are there drilling templates for this one? cant see them in the folder.

    Ps. thanks for the layout!

    ReplyDelete
  7. Yeah a drill template would be great.

    ReplyDelete
  8. Which side of the board should the potentiometers be mounted? I have tried using your legend in the "General Layout Notes" section, but have noticed the same blank pot shape being used for both component and solder side board-mounted layouts.

    ReplyDelete
    Replies
    1. Mount them from the solder side so the shafts of the pots are pointing away from the board.

      Delete
    2. Thanks -- I appreciate the response! I'll mount them such that they face upwards while the components point downwards. From what I understand, doing so seems to be the standard, so I'll try to keep it in mind while looking at your other designs unless their description says otherwise.

      Delete
  9. Verified! It sounds and looks fantastic.

    For anyone asking for a drilling template: Help yourself by finding an existing layout that fits the pot layout and enclosure size. Just be sure not to drill input/output jacks too close to the edge of the enclosure and to pick up some small knobs for this build (nothing wider than 5/8" skirt).

    Thanks again!

    ReplyDelete
  10. This comment has been removed by the author.

    ReplyDelete