This is a library of perfboard and single-sided PCB effect layouts for guitar and bass. I'm not an electrical engineer by any stretch of the imagination, just a DIY'er who likes drawing layouts. It is meant for the hobbyist (so commercial use of any of these layout is not allowed without permission) and as a way to give back to the online DIY community.

Thursday, July 30, 2020

Mad Professor Simble

This is been traced for a few weeks now over on FSB and I've meant to lay it out since then, but just now getting around to it. If you don't know, it's an amp-in-a-box type trying to emulate a Dumble amp. Apparently it sounds very good with smaller amps. Should fit nicely in a 1590B with board mounted pots as per usual.



20 comments:

  1. Just when I thought I was free...you pulled me back in, mark this one verified, sounds great.

    ReplyDelete
    Replies
    1. Thanks for verifying! I'll be waiting for parts on this one.

      Delete
  2. Pleace man, Line selector Boss!

    ReplyDelete
  3. I can't believe I missed this one.
    Very nice sounding pedal.
    I used an LM833 instead of the TLC2272

    ReplyDelete
  4. Verified. I like it very much. Thank you for sharing as always.

    ReplyDelete
  5. Best clone pedal I've ever played, Thank you.

    ReplyDelete
  6. I also made it with LM833. Very good pedal. Somehow similar to a Zendrive. I made it in one box with an Orange Squeezer with external Compression pot. This Simble just loves the squeezer. Seriosly, if you are a strat blues player these two are all what you need.

    ReplyDelete
  7. Hello, I'm note sure I'm reading good about 2 values. On the circuit I'm hesitating between 8.2nf and 82 nf for a capa. and between 2.2 M and 22M for a resistor. Can somebody confirm please.

    ReplyDelete
  8. Thank you very much for your answer. I'm gonna do it...

    ReplyDelete
  9. Well - I get output - how come it's not overdriving- any suggestions anyone?

    ReplyDelete
  10. Muy buen aporte!! Muchas gracias, funcionando a la primera!!

    ReplyDelete
  11. anyone got the schem for the simble booster?!

    ReplyDelete
  12. The pedal sounds beautiful but the volume is low. Only near the end of the potentiometer's travel does it exceed the volume of the off pedal. Is it a fault?

    ReplyDelete
    Replies
    1. The same low level issue here? Any idea about possible reason?

      Delete
    2. The same low level issue here. On the other hand, the gain is too high, it was far from mad professor's simble. Here was a higain

      Delete
  13. Thanks for sharing all this beautiful information!! Would a tl072 work?

    ReplyDelete
  14. Checked everything and still can't get anything out of the countour pot. Everything else works great.

    ReplyDelete
  15. hello everything is fine? I checked here and I didn't find the dumbloid? did you make a pcb for it?
    https://docs.pedalpcb.com/project/SpecialOD.pdf

    ReplyDelete