This is a library of perfboard and single-sided PCB effect layouts for guitar and bass. I'm not an electrical engineer by any stretch of the imagination, just a DIY'er who likes drawing layouts. It is meant for the hobbyist (so commercial use of any of these layout is not allowed without permission) and as a way to give back to the online DIY community.

Thursday, September 14, 2017

Wampler Sovereign

Here's another Wampler take on the JFET mu-amp design. This one adds a op amp stage at the output and features a Big Muff-style tone stack. This one's pretty versatile and a great sounding distortion. Ian sent me his perf layout of this one and I refined it a bit for what you see below, so a special thanks to him. Schematic can be found over on FSB.


21 comments:

  1. you are ... the stomp boxes prophet ``!!

    ReplyDelete
  2. You can mark it verified! The only thing I changed was the Mids pot, I connected lugs 1 and 2 to the 33nf cap and lug 3 to ground. It should work either way though.

    ReplyDelete
  3. I etched the pcb a while ago and just yesterday i populated the pcb. At first it does not fired up and after debugging i found our that the Gate on the Q2 is not connected on the pcb side. Now its working good.

    ReplyDelete
  4. Any schematic and parts list for this one?

    ReplyDelete
  5. Hi David, how are you ?
    What job do the 50k trimmer exactly ?
    How i have to adjust it ?

    Thx

    ReplyDelete
    Replies
    1. It's biasing Q5. Set it so you get about 4.5v on the drain and then adjust by ear if necessary.

      Delete
  6. ha ok i understand now why i have this sound like very compressed !!! :)
    Ok thanks for always respond us ...

    Franck

    ReplyDelete
  7. is there a schematic to this? that would be nice, thanks!

    ReplyDelete
  8. Verified, but it haven't that amount of distortion what i expected from yt demos. Anybody have similar impression? Q5 biased on 4.4v

    ReplyDelete
    Replies
    1. The same thing happens to me, it's like a soft overdrive

      Delete
  9. How about the Dracarys? Is there any chance of seeing it here? it would be great!

    ReplyDelete
  10. Good day to all. Refer to the diagram indicated in the top of the article is currently not available. Please tell me where else to find the scheme.

    ReplyDelete
    Replies
    1. Haven't found the schem anywhere else, and FSB is down. Hopefully it'll come back...

      Delete
  11. Fantastic. Super sound. Like a good amp. I used 100k for biasing and had some problems. Use 50k for fine biasing. Adjust sound just before compressing. Good luck.

    ReplyDelete
  12. Hi! What is the voltage measurement from ground to drain to set the trimmer resistor? Thank you

    ReplyDelete
    Replies
    1. Got the answer from previous comment ... thank you

      Delete
  13. Would there be any problem if I use electrolytic cap nonpolar to 1uF ...or mylar?

    ReplyDelete