Here's the early 80s DOD FX55 Distortion, without the original switching circuit so you can wire it for true bypass. The original used a TL062 dual op-amp, but the 2nd half of it wasn't in the signal path all, so I went with the single TL061. The off-board wiring pads aren't as neat as I'd like, but I wanted it to fit in a 1590a.
You could fairly easily use this same layout to make the DOD FX50 overdrive with the following mods:
• Change the 1k resistor to 4.7k
• Change the 3.9M resistor to 1M
• Place a 1n capacitor between lugs 1 and 3 on the Level pot
Where does distortion 1 go?
ReplyDeleteIt's not connected.
DeleteO Lug 1 do Drive é invertido mesmo?! Caso eu queira colocar 500KA eu teria que inverter correto?! Colocar o Lug 3 no 47nF junto com o Lug 2 e o Lug 1 teria que ir para o GND, correto?!
ReplyDeleteFuncionaria da mesma forma certo?!
ReplyDelete