Pages

▼

Friday, December 4, 2015

Bass FuzzDrive

Here's a cool bass fuzz designed by Derringer over on DIYSB. It's based around the classic DIY Bazz Fuss with built in blending circuit. Derringer mentioned that it might need a booster after it. The good ol' LPB-1 should do nicely. Just put it between the Blend pot and Volume pot. Here's the schematic.


at

6 comments:

  1. Marcus CorradiniOctober 30, 2018 at 10:31 AM

    The fuzz is more like a distortion, but it works. Low end is well preserved. You can tag it verified.

    ReplyDelete
  2. UnknownDecember 16, 2020 at 12:46 AM

    im confused bare with me here bc im new.. where is the blend 2 an where are the volume 2 and 3? also whats that 100k for- i highly value the work you do here and would very much appreciate any help

    ReplyDelete
    Replies
    1. UnknownDecember 16, 2020 at 12:59 AM

      err forget this i was too sleepy and didnt read the footnotes :)

      Delete
    2. UnknownDecember 16, 2020 at 1:00 AM

      no wait there is some things i cant understand. i stand by my first comment. sorry

      Delete
    3. Effects LayoutsDecember 16, 2020 at 10:09 AM

      Blend lug 2 gets wired to Volume 3. Volume 2 is the output. The 100k trimmer is for biasing the Q2 JFET. Usually you set it at 4.5v (half the supply voltage) and then fine tune by ear.

      Delete