Wednesday, June 29, 2016
Lovepedal Delux 60 Mosfet Boost
Hadn't done a boost pedal in a while and hadn't done a Lovepedal pedal in a while either, so I'm killing 2 birds with one stone. The Delux 60 uses a Mosfet gain stage set to give clean boost or to push a tube amp into break up. It's simple but effective. This'll fit into a 1590a pretty easily too.
Holaa... Aca puedo invertir el 2N7000???
ReplyDeleteYou can, though it might not be as loud as a BS170.
DeleteJust soldered it - works like a charm! Please tag it as verified.
ReplyDeleteCool. Thanks for verifying!
DeleteI don't have at home any 3K3 resistors. If I build it with 3K the result will be a slightly less loud booster? Or significantly less loud? I have 3K or 3K9 nothing in between.
ReplyDelete3k should be fine and shouldn't sound all that different.
DeleteIn the end I put there a 3K and a 300 Ohm resistor in a shrink tube. But it is too late to try it now...
DeleteWorking?
DeleteIt works, the drawing is good. I built a few pedals from the drawings here. Thanks for them.
ReplyDeleteAny hint on how to add gain pot? Thanks a bunch.been this site's fan since three four years ago and jad built several pedals from several posts in here.thank for your work storyboardist 😘😊
ReplyDeletePut like a C5k pot in place of the 330Ω resistor on the left side.
DeleteHi! Im new at diy's world. Can you show me how to wire this pcb to the input, output and 9v jacks?
ReplyDelete