Pages

▼

Tuesday, August 7, 2018

Nine Volt Nirvana Tape Measure

Found a bunch of Nine Volt Nirvana/Joe Gagan schematics on Fredd Brigg's blog. I'll probably do a few more of them, but first is the Tape Measure boost. Super simple and should easily fit in a 1590A. Original unit used a trimmer instead of an external volume control, but I figure most people will want the external control.

at

9 comments:

  1. AnonymousAugust 7, 2018 at 9:03 PM

    Looks cool! I imagine that the Nine Volt Nirvana projects will make for some fun Fuzz Friday postings.

    ReplyDelete
  2. UnknownAugust 8, 2018 at 11:45 PM

    Seriously?! I just found these too and was going to do some eagle layouts.

    ReplyDelete
  3. Лучше чем ничего...August 9, 2018 at 6:37 AM

    can I put here 2n5088?

    ReplyDelete
  4. Marcus CorradiniAugust 10, 2018 at 11:57 AM

    Verified. 25db of boost and a little overdrive.

    ReplyDelete
  5. resistanceAugust 18, 2018 at 5:48 PM

    could we run it at 18V?

    ReplyDelete
  6. Aleksandr 88December 20, 2019 at 3:34 AM

    Which side to put the pot on?

    ReplyDelete
    Replies
    1. Effects LayoutsDecember 20, 2019 at 3:01 PM

      The pot would be mounted on the solder side of the board.

      Delete
  7. Aleksandr 88December 20, 2019 at 3:35 AM

    Which side to put a variable resistor?

    ReplyDelete
    Replies
    1. Effects LayoutsDecember 20, 2019 at 3:02 PM

      Just adding one in place of a resistor? Either side, so whichever side it fits better on

      Delete