Got a request to redo the LPB-1 with the pot board mounted. Can't say I'm opposed and it only took about 5 min to layout. :) Easy fit in a 1590A. If you want to make the Screaming Bird treble booster, replace the two 100nF caps with 3.3nF.
Very Good https://sv1.picz.in.th/images/2019/02/16/TuQLLa.jpg https://sv1.picz.in.th/images/2019/02/16/TuQJAf.jpg https://sv1.picz.in.th/images/2019/02/16/TuQmkq.jpg https://sv1.picz.in.th/images/2019/02/16/TuQyOz.jpg
Build it with BC550C works perfectly then integrating with green russian muff and...voila now i have another variant like Blackout Effector Musket Fuzz and brutal enough playing with drop C...!!!
How do I connect the on / off switch? in fact, how do I connect the switch in all the diagrams on the page, since almost none say how to make the connection?
Why are some of the resistor values of this version different from the previous version? Is it to have more common values? Do the new values change anything audibly?
This is verified ( if you had any doubt lol ). Perfect timing because I needed a screaming bird, thanks!!
ReplyDeleteRealy sir? i made the 1st layout and it didnt work..
ReplyDeleteis this verified?
ReplyDeleteSee above comment.
DeleteVery Good
ReplyDeletehttps://sv1.picz.in.th/images/2019/02/16/TuQLLa.jpg
https://sv1.picz.in.th/images/2019/02/16/TuQJAf.jpg
https://sv1.picz.in.th/images/2019/02/16/TuQmkq.jpg
https://sv1.picz.in.th/images/2019/02/16/TuQyOz.jpg
https://www.facebook.com/fxman1985/posts/361935534628023
А куда правильно Припять резистор на 100k?
ReplyDeleteТак три точки на плате во второй строке и есть ноги потца. Эта плата с учетом на то, что потц в плату впаивается
DeleteBuild it with BC550C works perfectly then integrating with green russian muff and...voila now i have another variant like Blackout Effector Musket Fuzz and brutal enough playing with drop C...!!!
ReplyDeleteHi. Can I replace the 2N5088 with the 2N3904? Do the values of R and C remain unchanged? Thank you so much
ReplyDeleteYou should be ok with a 3904. No changes necessary
DeleteOK, I'll try.
DeleteThank's!
This comment has been removed by the author.
ReplyDeleteHow do I connect the on / off switch? in fact, how do I connect the switch in all the diagrams on the page, since almost none say how to make the connection?
ReplyDeleteGo to the general layout notes tab for off board wiring
DeleteVerified, if needed! at first I thought that the potentiometer was linear, instead it is logarithmic. nothing serious!
ReplyDeleteso this works, but it doesn't work with an LED. When I hook up an LED it seems to siphon off too much power and just shuts off?
ReplyDeleteWhy are some of the resistor values of this version different from the previous version? Is it to have more common values? Do the new values change anything audibly?
ReplyDelete