The Boosta Grande is a simple opamp-based boost that's pretty similar to the MXR Micro Amp. Only differences being where the pot is in the circuit and component value changes. Offers up to +20dB of boost. Should fit in a 1590A if you don't board mount the pot.
It works well without problems has a decent gain, but the gain of the MXR Micro Amp is at least twice as much, I think it is not this time, I replace my clone of Micro Amp. Thank you! By the excellent circuits, I hope you continue for a long time.
Its not working. On the original schematic I saw a C1=220uF after diode that could be for ripple and is missing here. Othre question is C10 appear as 1000uF and here is 100uF. Using a test probe test I can hear sound on input pin 2 on TL071, but no sound on pin 6 of TL076. On capacitor c6=5n6 and resitor r8=10K the voltage is dropping from 4 to 3 volts. I only potenciometer from C10K to B10k and others is the same.
It works well without problems has a decent gain, but the gain of the MXR Micro Amp is at least twice as much, I think it is not this time, I replace my clone of Micro Amp.
ReplyDeleteThank you! By the excellent circuits, I hope you continue for a long time.
This comment has been removed by the author.
Deleteplease more BBE!!!
ReplyDeleteIt's verified, my friend!
ReplyDelete
ReplyDeleteDo you have a project Sonic Stomp BBE?
this is a cool sound!!!
Guys... can I replace the C10K pot with a B10K?
ReplyDeleteNot able to find the exact component in this god forsaken place ... :S
B10k will work. The sweep of the pot might be a little off from the original, but it'll still function fine.
Deleteyou could also wire an a log A type pot backwards
Deleteyou could also wire an a log A type pot backwards
DeleteIt's working, nice gain! I will try to find the C10K because the B10K seems to go from 0 to 100 in the last 5% :S
ReplyDeletecan i use a linear pot for that ??
ReplyDeleteYes, the sweep will be a little off, but it should still work.
Deletethanx
DeleteIts not working. On the original schematic I saw a C1=220uF after diode that could be for ripple and is missing here. Othre question is C10 appear as 1000uF and here is 100uF. Using a test probe test I can hear sound on input pin 2 on TL071, but no sound on pin 6 of TL076. On capacitor c6=5n6 and resitor r8=10K the voltage is dropping from 4 to 3 volts. I only potenciometer from C10K to B10k and others is the same.
ReplyDeleteThis comment has been removed by the author.
DeleteHello again, my issue was solved after change TL071 from another brand. The 3 TL071 that a tested before are fake.
ReplyDelete