BBE Boosta Grande

The Boosta Grande is a simple opamp-based boost that's pretty similar to the MXR Micro Amp. Only differences being where the pot is in the circuit and component value changes. Offers up to +20dB of boost. Should fit in a 1590A if you don't board mount the pot.

FuzzHugger FX Algal Bloom

Here's another cool fuzz from FuzzHugger for Fuzz Friday. The Algal Bloom is transistor based with a wide range of tones, from mild overdrive to full on fuzz. It has the Gain and Level controls you'd expect, along with a Bloom control (expands the fuzz tone), Clean (blend), and Power (voltage sag), along with 2 toggle switches for more things to tweak. Originals have the Clean control internally, but who doesn't love more controls? It's laid out with board mounted pots to fit in a 125B enclosure with top mounted jacks.

Auto Swell

Someone showed me this circuit and it's a cool addition to this library. It's an old project from Electronics & Music Makers magazine and allows you to ramp up and down your volume. It's not a true-bypass pedal, but essentially an always-on boost that increases your volume when the momentary footswitch is pushed. More info and schematic can be found in these scans:

Black Arts Toneworks Black Forest

This is Black Arts' take on the Colorsound Overdriver. There are a few component value changes and 6 different caps on a 2 pole, 6 position rotary switch at the input. It's got a wide range of tones, and goes from boost to overdrive to fuzz. It's laid out for board mounted pots and would fit in a 1590B if it weren't for the rotary. If you wanted to skip the rotary and just use one input cap, just populate the capacitor you want and jumper its corresponding pad to the SwA pad.

Hornby Skewes Zonk Machine II

The Zonk Machine II was the more budget friendly version of the Zonk Machine. It was a simplified circuit and featured silicon transistors in place of germanium. Originals used 2N4061 PNP silicons, but other could be used. Because it's silicon based, it shouldn't be too hard to make the swap to NPNs so it can be daisy chained with other negative ground effects. I've laid out 2 versions of this, one for BCE pinout transistors (like the original 2N4061s) and one for CBE pinout transistors. The perf layouts reflects the original positive ground configuration, and the PCB layouts reflect negative ground configuration. Note that the 3.9k resistor isn't always necessary (it's there to make the Fuzz pot value 2k). Here's the schematic for reference.

Frantone Vibutron

Here's another one of my Eagle creations. The Vibutron is a great sounding tremolo from Frantone that uses a ICL8038 to produce the LFO. Originals use a rotary switch for selecting the waveform, but as lvlark pointed out on the Tagboard Effects blog, a on/on/on DPDT switch can be used instead (check out his layout for switch wiring). For you perf builders, this might be a bit difficult to translate to perf (especially with 3 traces under the 8038), but I'm sure one of you out there will make it work. :D This layout has also been uploaded to OshPark if you want a fabricated board–click the OshPark tab above.

Note: Red lines are jumpers

Way Huge Green Rhino Mk II

Here's the newest version of the Green Rhino from Way Huge. It's similar to a Tube Screamer, but with a few extra stages and lots of modifications. I've laid it out for board mounted pots in a 1590BB. Here's the schematic for reference.