tag:blogger.com,1999:blog-5481402030233340127.post2575320051590921934..comments2024-03-28T17:24:07.520-04:00Comments on Perf and PCB Effects Layouts: Durham Sex Drivedtgehringhttp://www.blogger.com/profile/09555201436004501222noreply@blogger.comBlogger5125tag:blogger.com,1999:blog-5481402030233340127.post-7278187793137690222023-05-08T12:02:14.120-04:002023-05-08T12:02:14.120-04:00Some LED's in the top right image are miss-lab...Some LED's in the top right image are miss-labeled FYI,NOChttps://www.blogger.com/profile/04777017979825354934noreply@blogger.comtag:blogger.com,1999:blog-5481402030233340127.post-79417129601676089492017-12-19T19:25:15.876-05:002017-12-19T19:25:15.876-05:00This comment has been removed by the author.JAC3https://www.blogger.com/profile/04712480008697688980noreply@blogger.comtag:blogger.com,1999:blog-5481402030233340127.post-35633851387496536612017-12-19T19:20:39.432-05:002017-12-19T19:20:39.432-05:00Using a probe, I can't anything past the 47k r...Using a probe, I can't anything past the 47k resistor to the 1uf cap. I've made one of these before from the same batch of etched boards and just can't figure out what is going wrong. <br /><br />I've desoldered and replaced all components around it. Any ideas?JAC3https://www.blogger.com/profile/04712480008697688980noreply@blogger.comtag:blogger.com,1999:blog-5481402030233340127.post-79688418330942139722017-06-08T12:19:34.631-04:002017-06-08T12:19:34.631-04:00Thanks for verifying. The LEDs are probably not go...Thanks for verifying. The LEDs are probably not going to light up as they're only being used as soft clipping diodes and aren't going be getting enough voltage to light up in the feedback loop of the IC. I've only had one pedal that had LED clippers that actually lit up and they were hard clippers in a RAT. Effects Layoutshttps://www.blogger.com/profile/11341183658959824998noreply@blogger.comtag:blogger.com,1999:blog-5481402030233340127.post-35255682500115555242017-06-08T11:57:34.837-04:002017-06-08T11:57:34.837-04:00I built it and it works. But I have a question: ho...I built it and it works. But I have a question: how to correctly insert the red LEDs and should they light up when the pedal is turned on?Anonymoushttps://www.blogger.com/profile/12328268360909152572noreply@blogger.com