tag:blogger.com,1999:blog-5481402030233340127.post5948561691631863131..comments2024-03-28T17:24:07.520-04:00Comments on Perf and PCB Effects Layouts: Jack Deville Deuce Coupedtgehringhttp://www.blogger.com/profile/09555201436004501222noreply@blogger.comBlogger3125tag:blogger.com,1999:blog-5481402030233340127.post-35432794053417957032017-10-23T13:59:38.704-04:002017-10-23T13:59:38.704-04:00thanks for pointing that out I should have started...thanks for pointing that out I should have started out my reply with, If you use a MAX1044. bcruzin2https://www.blogger.com/profile/07686224394634037167noreply@blogger.comtag:blogger.com,1999:blog-5481402030233340127.post-30756938048337895802017-10-23T10:56:37.269-04:002017-10-23T10:56:37.269-04:00Cool. Thanks for verifying! Note to future builder...Cool. Thanks for verifying! Note to future builders that the 1054 and 1044 aren't directly interchangeable. So if you're using the 1054, build it as is, but if you're using the 1044, jumper pins 1 and 8 like Bill did.Effects Layoutshttps://www.blogger.com/profile/11341183658959824998noreply@blogger.comtag:blogger.com,1999:blog-5481402030233340127.post-90040626211775852552017-10-23T10:53:48.569-04:002017-10-23T10:53:48.569-04:00I built this over the weekend, you need to connect...I built this over the weekend, you need to connect pin 1 and 8 on the LT1054. I used a MAX1044, and once I jumpered the pins it sounded Great.bcruzin2https://www.blogger.com/profile/07686224394634037167noreply@blogger.com